Kawasaki Ninja 250R Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi, I've installed 4 LED indicators on my 2009 ninja 250r. I've replaced the flasher, installed a diode harness kit and resisters at the rear indicators.
The indicators do work but there are a couple issues:

1. When riding bike and revving, indicators flash normally at normal rate, however when bike is idling the flashing slows down and eventually becomes solid, as i accelerate they start flashing again.

2. When ignition is on but engine off the indicators are solid and do not flash.

Any ideas would be much appreciated.

Thanks.
 

· Registered
Joined
·
419 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top