Kawasaki Ninja 250R Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My 250 was leaking oil from where the wires come out of the case for the generator so I pulled it apart to replace the gasket and sealer around the rubber grommet. I thought I remembered where everything went but it appears my memory isn't as good as I thought (imagine that lol)

Does anyone have a picture or diagram of how the wires are routed inside the casing? I thought they passed under the pick up coil but the wires from the generator are too long or not long enough, depending on which way I orient the coils.

Also, I have a U shaped plastic piece that fell out of the cover somewhere and I can't determine where is goes. The parts manual calls it a damper but doesn't show where it attaches.

Thanks for any help! :)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top