Hey guys, I just installed some front blinkers the other day since the bike was missing them when I bought it. The correct side comes on when I hit the directional but the blinker just stays solid. I was wondering could it be my relays?? Any info is greatly appreciated, thanks.
Replace the flasher. You can use;
1.) FL552/536LL Electronic flasher or If you have more than 4 LED units you will need;
2.) Tridon EP34 relay- Can be found at just about any autoparts store, or can be easily ordered from amazon. It has 3 prongs, each marked B,L,& E. You ground the E pin on the relay. To do this, you need about 12" of wire, attach a 14gauge female spade connector to one end and a ring terminal on the other end. You slip the female spade connector onto the E-pin, then screw the ring terminal to a ground somewhere on your bike.
3.) CF12ANL-01 flasher relay- It has 2 prongs just like the stock flasher so you don't need to add any ground wires, but you will likely need to order from this website http://www.superbrightleds.com/cgi-b...2Fflashers.htm. as they aren't found at your local auto store or amazon.
These methods have been tested and proven to work.
Thanks for all the info man I really appreciate it, I managed to fix my stock relay but ordered a new led flasher regardless. I recently installed the led flasher and everything is going much smoother than the stock, looking into rear led signals next.