Vtec44
09-16-2008, 11:27 PM
I did this for ScratchOn.com, but might as well post it here. You can find it at http://www.scratchon.com/store/powersports-kits/rim-tapes-pre-curved/. We may do a few free giveaways on these. :D
Before you begin, make sure the surface is clean and free of dust and other debris.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=70&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0638.jpg)
To start, you will need one end of the pre-curved tape to fully stay in place on the rim.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=69&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0639.jpg)
You can then use your thumb to align and rub the outter edges of the tape to stick to the rim.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=68&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0642.jpg)
With only the outter edges of the tape stuck to the rim, you can visually double check the alignment and make changes if needed.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=67&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0640.jpg)
If everything is correct, you can gently run your fingers over the tape to stick it to the rim.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=66&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0644.jpg)
Towards the end, if you have excess tape, you can cut it off and let it overlap a little.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=65&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0643.jpg)
The end result.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=64&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0645.jpg)
Before you begin, make sure the surface is clean and free of dust and other debris.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=70&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0638.jpg)
To start, you will need one end of the pre-curved tape to fully stay in place on the rim.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=69&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0639.jpg)
You can then use your thumb to align and rub the outter edges of the tape to stick to the rim.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=68&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0642.jpg)
With only the outter edges of the tape stuck to the rim, you can visually double check the alignment and make changes if needed.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=67&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0640.jpg)
If everything is correct, you can gently run your fingers over the tape to stick it to the rim.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=66&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0644.jpg)
Towards the end, if you have excess tape, you can cut it off and let it overlap a little.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=65&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0643.jpg)
The end result.
http://www.scratchon.com/wp-content/plugins/nextgen-gallery/nggshow.php?pid=64&width=320&height=240&mode= (http://www.scratchon.com/wp-content/gallery/instructions/dscf0645.jpg)